Hydrodynamics in cavitation device under tangential supply fluid

Authors

  • N. І. Horodyskyi ТНТУ імені Івана Пулюя, Тернопіль, Ukraine
  • Т. М. Vitenko ТНТУ імені Івана Пулюя, Тернопіль, Ukraine

DOI:

https://doi.org/10.20535/2521-1943.2018.82.128285

Keywords:

cavitation, hydrodynamics, bubbles, collapse, fluid pressure, SolidWorks

Abstract

The design features of the hydrodynamic type cavitation device working section with the input swirling flow are theoretically analyzed. In order to describe such processes was used the flow hydrodynamics modeling performed with the help of numerical methods of the SolidWorks software system and the Flow simulation module. Comparison of results from visual and experimental studies are performed. Visual observations indicate that the life cycle of vapor-gas bubbles and cavities in the design under study can be divided into several periods, in particular the formation of vapor-gas bubbles, their growth, the generation of cavities, volume increase, transformation and destruction. The influence of input and output hydrodynamic and technological parameters of the flow and the design features on the character of the cavitation site and the form of cavitation were studied. According to the results of theoretical and experimental research, rational mode of operation of the cavitation device is proposed. The frequency of oscillations (pulsations) of a cavity is calculated, depending on Reynolds number and Strouhal number. For the dependence Sh = f (Re, P2 / P1), the regression coefficients are calculated, and adequate experimental results with an error of less than 10% are obtained.

References

  1. Dolinsky, A. A. and Ivanitsky, G.K. (2003), “The principle of discrete-pulse energy input–new approach to the development of efficient power-saving technologies”, Ann. Review of Heat Transfer.–N.Y. Wallingford (UK): Begell House Inc, pp. 225-233.
  2. Dolinsky, A. A. and Ivanitsky, G.K. (1996), “Theoretical justification of the principle of discrete-pulse energy input. II. The study of the behavior of the ensemble of vapor bubbles”, Industrial Heat Engineering, vol. 18, no. 1, pp. 3-20.
  3. Luhovskoi, A.F. and Chukhraev, N. V. (2007), Ul'trazvukovaya kavitatsiya v sovremennykh tekhnologiyakh [Ultrasonic cavitation in modern technologies], Vydavnycho-polihrafichnyi tsentr «Kyivskyi universytet», Kiev,Ukraine.
  4. Chen, L.D. and Faeth, G.M. (1982), ”Condensation of Submerged Vapor Jets in Subcooled Liquid”, Ibid, vol. 10, no. 4, pp. 179-187.
  5. Vitenko, T. M. and Humnytskyi, Ya. M. (2009), “Effect of steam-gas phase on kinetics of dissolution under cavitation conditions”, East European magazine of advanced technology, no. 3/6(39), pp. 4-8.
  6. Cerone, P.and Blake, J.R. (1984), “Anote on the instantaneous streamlines, pathlines and pressure contours for a cavitetion bubble near a boundary”, J. Austral. Math. Soc.Ser., pp. 31-44.
  7. Tomita, Y. and Shima, A. (1986), “Machanism of impulsive pressure generation and damage pit formation by bubble collaps”, J. Fluid Mach., pp. 535-564.
  8. Akhmetov, Yu. M., Kalymullyn, R. R. and Tselyshchev V. A. (2010), “Numerical and physical modeling of fluid flow in a vortex heat generator”, vol. 14, no. 4(39), pp. 42-49.
  9. Baturyn, O. V., Baturyn, N. V. and Matveev, V. N. (2009), Raschet techenii zhidkostei i gazov s pomoshch'yu universal'nogo programmnogo kompleksa Fluent [Calculation of flows of liquids and gases with the help of the universal software package Fluent], Samara Publishing House. state. aerospace. un-ta, Samara, Russia.
  10. Pilipenko, V.V. (1989), Kavitatsionnye avtokolebaniya [Cavitation self-oscillations], Naukova dumka, Kiev,Ukraine.
  11. Pilipenko, V.V., Man’ko, I.K. and Zadontsev, V.A. (1998), “Cavitation self-oscillations intensify technological processes”, Proceedings of a Fluid Dynamics Panel Workshop, no. 827, pp. 32-1÷32-4.
  12. Pilipenko, V.V., Man’ko, I.K., Zadontsev, V.A. and Dovhotko, N.I. (1976), O vysokochastotnykh kolebaniyakh v gidravlicheskoi sisteme za kavitiruyushchei trubkoi Venturi [About high-frequency oscillations in the hydraulic system behind the cavitating Venturi tube], 2nd edn., Naukova dumka, Kiev, Ukraine.
  13. Pilipenko, V.V., Man’ko, I.K., Zadontsev, V.A., Zhulai, Yu.A. and Dzoz, N.A. (1986), Generator kolebanii davleniya zhidkosti [Fluid pressure oscillation generator], SSSR, Pat. № 3772504/24-28.
  14. Man’ko, I.K (1976), Vizual'nye issledovaniya kavitatsionnykh avtokolebanii v gidravlicheskoi sisteme s prozrachnoi trubkoi Venturi [Visual studies of cavitation self-oscillations in a hydraulic system with a transparent Venturi tube], 2nd edn., Naukova dumka, Kiev, Ukraine.

Published

2018-05-01

How to Cite

[1]
Horodyskyi N. І. and Vitenko Т. М., “Hydrodynamics in cavitation device under tangential supply fluid”, Mech. Adv. Technol., no. 1(82), pp. 107–115, May 2018.

Issue

Section

Original study