РЕСУРСОЗБЕРІГАЮЧИЙ ТЕХНОЛОГІЧНИЙ ПРОЦЕС ВИГОТОВЛЕННЯ КІЛЬЦЕВИХ ФЛАНЦІВ

Authors

  • С. П. Гожій National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • А. В. Кліско National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • А. І. Носенко National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.69819

Keywords:

The article presents the results of development of economical technologies of production of ring flange parts

Abstract

The article is devoted determination and research of perspective directions of development of a rotary forming. The article presents the results of development of economical technologies of production of ring flange parts. A distinctive feature of the process is almost complete absence of waste and operations with the removal of chips. The products have a minimum cost with a sufficient quality. The experiments were carried out at the department of mechanics of plasticity of materials and resource-saving processes. Directions of further experimental and theoretical researches are set.

Author Biographies

С. П. Гожій, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р.техн.наук

А. В. Кліско, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

асп.

А. І. Носенко, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

маг.

Downloads

Published

2016-07-15

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.