МОДЕЛЮВАННЯ ПРОЦЕСУ ПРОФІЛЮВАННЯ КАНАВОК НА ТРУБАХ РОЛИКОВИМ ОБКОЧУВАННЯМ

Authors

  • В. О. Маковей National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • П. Ю. Проценко National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.73556

Keywords:

For each process, the results obtained by the intensity distribution of stress across the thickness of the formed grooves on the pipe steel X1810T at each stage of formation

Abstract

The simulation rolling ribbed pipe was performed eight rollers, and one sharp roller. For each process, the results obtained by the intensity distribution of stress across the thickness of the formed grooves on the pipe steel X1810T at each stage of formation. The results of modeling these processes were compared to find the optimal parameters of the process running. They are in good agreement with experimental data.

Author Biographies

В. О. Маковей, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук, доц.

П. Ю. Проценко, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

асп.

Downloads

Published

2016-07-12

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.