РОЗРОБКА СИСТЕМИ АВТОМАТИЗАЦІЇ ПРОЕКТУВАННЯ ВХІДНИХ ДАНИХ ДЛЯ ПРОГРАМНОГО КОМПЛЕКСУ «PLAST»

Authors

  • В. Л. Калюжний National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • І. В. Оконський National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.73595

Keywords:

Design patterns MVC, «Strategy» and «Decorator» were used in designing of the system Programming language C , development environment Microsoft Visual Studio 2010 and the Qt framework were used in implementing the MetalForming

Abstract

The software called MetalForming designed to facilitate and speed up entering of the input data for program complex called «PLAST» was created. MetalForming is a functionally simplified Computer-Aided Design system. Design patterns MVC, «Strategy» and «Decorator» were used in designing of the system. Programming language C++, development environment Microsoft Visual Studio 2010 and the Qt framework were used in implementing the MetalForming.

Author Biography

В. Л. Калюжний, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р.техн.наук

Downloads

Published

2016-07-13

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.