ПІДВИЩЕННЯ ТОЧНОСТІ ОБРОБКИ НА ТОКАРНИХ АВТОМАТИЗОВАНИХ ВЕРСТАТАХ ШЛЯХОМ МІКРОРЕГУЛЮВАННЯ ПОЛОЖЕННЯ РІЗЦЯ

Authors

  • Ю. В. Петраков National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • В. В. Писаренко National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.59.77238

Keywords:

In article the requirements and the recommendation about designing of tool equipment with elastic ways are given

Abstract

One of ways of the decision of a problem of increase of accuracy and productivity of processing on the turning automated machine tools is use of tool equipment with elastic ways for microadjustment of the cutters for compensation of regular components of an error of turning processing. In article the requirements and the recommendation about designing of tool equipment with elastic ways are given.

Author Biographies

Ю. В. Петраков, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р.техн.наук, проф.,

В. В. Писаренко, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

магістр

Downloads

Published

2016-10-04

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.