ДОСЛІДЖЕННЯ ТОЧНОСТІ ОБРОБКИ КІЛЬЦЕВИХ ДЕТАЛЕЙ ІЗ ЗМІНОЮ ВХІДНИХ ПАРАМЕТРІВ

Authors

  • О. В. Литвин National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • В. Г. Кушик National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.59.78926

Keywords:

technological system of lathe to the machine-tool is conducted in work, multifist selfcentring patron, on exactness of treatment of non-rigid details as bearing rings

Abstract

Research of influencing of descriptions of the technological system of lathe to the machine-tool is conducted in work, and of multifist selfcentring patron, on exactness of treatment of non-rigid details as bearing rings. At the design of process of treatment got transversal cuts details on which evidently influence of clamping elements and technological heredity on exactness of treatment.

Author Biographies

О. В. Литвин, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук, доц.

В. Г. Кушик, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук, доц.

Downloads

Published

2016-10-04

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.