ВЛИЯНИЕ ВИДА МЕХАНИЧЕСКОЙ ОБРАБОТКИ НА СТРУКТУРУ ПОВЕРХНОСТНЫХ СЛОЕВ СТАЛИ ХВСГ

Authors

  • А. Д. Котляр Институт проблем материаловедения им.И.Н. Францевича, Ukraine
  • В. С. Антонюк Национальной академии наук Украины, г.Киев,
  • Ю. А. Федоран National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv,

DOI:

https://doi.org/10.20535/2305-9001.2011.63.54493

Keywords:

structural condition of surface steel layers of ХВСГ are resulted at machining

Abstract

Results of machining kind influence researches and a tool material on a structural condition of surface steel layers of ХВСГ are resulted at machining. Advantage of turning processing by cutters from geksanit-R in comparison with grinding process is shown. Processing by geksanit-R tool in a surface layer for α - and γ - phases is accompanied only by compressing residual pressure while abrasive processing promotes occurrence of stretching pressure of an I-type in α - a phase of structure of high-speed admission.

Author Biographies

А. Д. Котляр, Институт проблем материаловедения им.И.Н. Францевича

канд.техн.наук

В. С. Антонюк, Национальной академии наук Украины, г.Киев

д-р техн.наук

Downloads

Published

2015-11-25

Issue

No. 63 (2011)

Section

Статті

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.