INCREASING EFFICIENCY OF HYDROSTATIC BEARINGS
DOI:
https://doi.org/10.20535/2305-9001.2015.75.58369Keywords:
spindle, precision, hydrostatic support, energy, trajectory, pressure, load-bearing capacitAbstract
The rational design and operating parameters of the radial hydrostatic bearings, allowing to increase the amount of load-bearing capacity. Calculated dimensionless bearing capacity and the pressure in the pockets of the hydrostatic radial bearings at circuit design from different angles and different forms of execution pockets. Ways of improving the energy efficiency of high-speed design solutions supports (more than 20,000 min-1), based on the use of special systems to deliver oil to the pockets of support using low-viscosity grease.
References
Strutins'kij V.B., Fedorinenko D.Ju. Statistichna dinamіka shpindel'nih vuzlіv na gіdrostatichnih oporah: monografіja. V.B.Strutins'kіj, D.Ju.Fedorinenko. Nіzhin: TOV "Vidavnictvo "Aspekt-Polіgraf", 2011. 464 p.
Fedorinenko D.Ju., Bojko S.V., Sapon S.P. Poshuk prostorovoї funkcії tisku v regul'ovanomu radіa-l'nomu gіdrosta-tichnomu pіdshipniku zasobami sistemi CosmosFloWorks. D.Ju.Fedorinenko, S.V. Bojko, S.P. Sapon. Promislova gіdravlіka і pnevmatika. 2012. No 2(36). P. 61 - 65.
Detali i mehanizmy metallorezhushhih stankov. [Kaminskaja V.V., Levina Z.M. i dr]; pod red. D.N. Reshetova. Moscow: Mashinostroenie, 1972. 519p. (Shpindeli i ih opory, mehanizmy i detali privodov; t. 2).
Korovchinskij M.V. Prikladnaja teorija podshipnikov zhidkostnogo trenija. M.V. Krovchinskij. Moscow: MiS, 1954. 186 p.
Bushuev V.V. Gidrostaticheskaja smazka v stankah. V.V. Bushuev. Moscow: Mashinostroenie, 1989. 176 p.
Gorkusha A.Ju. Pіdvishhennja nesuchoї zdatnostі pіdshipnikіv kovzannja polіpshennjam teplovogo balansu robochih zon. A.Ju. Gorkusha, O.D. Molchanov, V.G. Stedljanko. Naukovі pracі Donec'kogo nacіonal'nogo tehnіchnogo unіversitetu. 2004. Vip. 71. P.151 – 159.
