Problems in production of uniformed, hollowed push-pull rods

Authors

  • Krzysztof Lukasik Lublin University of Technology, ul. Nadbystrzycka 36, 20-618 Lublin, Poland
  • Volodimir Ivanovich Stebliuk National University of Ukraine, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.60.62803

Abstract

The article presents the results of research on uniformed push-pull rods endings. The aim of research was the analysis of
characteristics and the possibility of durability improvement, in particular fatigue durability. The research included microstructure analysis
and numerical modelling of manufacturing process. The influence of technological parameters on characteristics improvement was also
analysed. The obtained results will be used to develop a new method of forming, and to produce sample elements which will be subjected to
verification trials.
Key Words: push pull rods, microstructure examination, computer modeling, neck forming

Downloads

Published

2016-03-18

Issue

No. 60 (2010)

Section

Статті

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.