ОПРЕДЕЛЕНИЕ ФОРМЫ, РАЗМЕРОВ ОЧАГА ДЕФОРМАЦИИ И ЭНЕРГОСИЛОВЫХ ПАРАМЕТРОВ ПРОЦЕССА РЕЗКИ ТОНКОСТЕННОЙ ТРУБЧАТОЙ ЗАГОТОВКИ ПАРАМИ ВРАЩАЮЩИХСЯ ОПРАВОК

Authors

  • В. И. Стеблюк National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • Д. Н. Савченко National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • Д. Б. Шкарлута National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.69805

Keywords:

All necessary data for create, by program methods, the diagrams P(φ) and M(φ), that are needed for determine the energy-force parameters of a cutting is prepared

Abstract

The second stage of the process non-polluting cutting thin tubular preparations at simultaneous cross shift and torsion are considered. The shape and sizes of the deformation zone, and also the sizes of zones of contact tubular preparation with elements of technological equipment are fixed. Main relations, which describe cutting tubular preparations, are established. All necessary data for create, by program methods, the diagrams P(φ) and M(φ), that are needed for determine the energy-force parameters of a cutting is prepared.

Author Biographies

В. И. Стеблюк, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р.техн.наук, проф.

Д. Н. Савченко, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

асп.

Д. Б. Шкарлута, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

инж.

Downloads

Published

2016-07-15

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.