АНАЛІЗ СИЛОВИХ РЕЖИМІВ ТА ЯКОСТІ ВИРОБІВ ПРИ ОБЖИМІ ТРУБЧАТИХ ЗАГОТОВОК В КОНУСНІЙ МАТРИЦІ

Authors

  • О. В. Калюжний National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.69823

Keywords:

The analysis of drafting of tubular blanks made of low-carbon steel was carried out by finite element method

Abstract

The analysis of drafting of tubular blanks made of low-carbon steel was carried out by finite element method. The influence of die’s geometry on the load modes of deformation and on maximum draft ratio were determined. The final geometry of detail, mode of deformation and metal strengthening after deformation were determined. Die block for process realization on production was designed according to analysis data.

Author Biography

О. В. Калюжний, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук, ст.викл.

Downloads

Published

2016-05-26

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.