ДОСЛІДЖЕННЯ УЩІЛЬНЮВАНОСТІ МЕТАЛЕВИХ ПОРОШКІВ ПРИ ПРЕСУВАННІ ЗА ДОПОМОГОЮ КОМПЛЕКСУ "ТЕНЗОР"

Authors

  • Г. А. Баглюк National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • О. І. Хоменко Інститут проблем матеріалознавства ім. І.М. Францевича НАН України, м. Київ, Ukraine
  • А. О. Хоменко Інститут проблем матеріалознавства ім. І.М. Францевича НАН України, м. Київ, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.73555

Keywords:

This paper deals with metallic powders and their mixtures compactibility investigation using "TENSOR" hardware-software complex with an example of Cu - Cr (30 % mass)

Abstract

This paper deals with metallic powders and their mixtures compactibility investigation using "TENSOR" hardware-software complex with an example of Cu - Cr (30 % mass) powders mixture. It was found that compactibility test results did not conflict with calculation based on plasticity theory and data obtained during test diagram continious record had less spread that one derived from discrete load tests.

Author Biographies

Г. А. Баглюк, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р.техн.наук, ст.наук.спів.

О. І. Хоменко, Інститут проблем матеріалознавства ім. І.М. Францевича НАН України, м. Київ

канд.техн.наук, ст.наук.спів

А. О. Хоменко, Інститут проблем матеріалознавства ім. І.М. Францевича НАН України, м. Київ

студ.

Downloads

Published

2016-07-12

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.