ОПРЕДЕЛЕНИЕ КИНЕМАТИЧЕСКИХ ГЕОМЕТРИЧЕСКИХ ПАРАМЕТРОВ КОНИЧЕСКИХ ПЕРЕДНЕЙ И ЗАДНЕЙ ПОВЕРХНОСТЕЙ СФЕРИЧЕСКИХ КОНЦЕВЫХ ФРЕЗ

Authors

  • В. В. Вовк National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • В. А. Токунов National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.59.76825

Keywords:

definition geometrical parameters of the spherical end milling cutters with conical front and back surfaces in the kinematics system of co-ordinates is solved in the articles

Abstract

The problem of definition geometrical parameters of the spherical end milling cutters with conical front and back surfaces in the kinematics system of co-ordinates is solved in the articles. Based on these relationships and the analysis of the influence of tilt angles, the advance axis cutter and feed on the kinematics geometric parameters may define such of their value at which they change along the cutting edge does not exceed the specified value.

Author Biographies

В. В. Вовк, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

ас.

В. А. Токунов, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

маг.

Downloads

Published

2016-09-05

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.