СПЕЦИФИKA ПРОЦЕССА РЕЗАНИЯ МРАМОРА PERLATO

Authors

  • Л. М. Танович Машиностроительный факультет Белградского университета, Белград, Сербия, KTH Миливое В. Шливанчанин , «Энергомермеринвест», Белград, Сербия, Serbia
  • М. Д. Попович Машиностроительный факультет Белградского университета, Белград, Сербия, KTH Миливое В. Шливанчанин , «Энергомермеринвест», Белград, Сербия, Serbia

DOI:

https://doi.org/10.20535/2305-9001.2010.59.77322

Keywords:

The level of application of marble products is closely connected to the quality of machining, that is measurement accuracy and the quality of the machined surface

Abstract

The level of application of marble products is closely connected to the quality of machining, that is measurement accuracy and the quality of the machined surface. The technological basis for economic marble machining implies a thorough understanding of the interaction which occurs between the abrasive grain an the marble material. The paper presents the results in the area of filings which form during micro cutting, as well as the analysis of the change of cutting force and the grinding wheel profile, relative to the change of machined elements, during Perlato marble cutting.

Author Biographies

Л. М. Танович, Машиностроительный факультет Белградского университета, Белград, Сербия, KTH Миливое В. Шливанчанин , «Энергомермеринвест», Белград, Сербия

профессор

М. Д. Попович, Машиностроительный факультет Белградского университета, Белград, Сербия, KTH Миливое В. Шливанчанин , «Энергомермеринвест», Белград, Сербия

ассистент

Downloads

Published

2016-09-12

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.