МАТЕМАТИЧНЕ МОДЕЛЮВАННЯ ХОЛОДНОГО КОМБІНОВАНОГО ВИДАВЛЮВАННЯ ЗАГОТОВОК ІЗ СТАЛІ 20

Authors

  • В. Л. Калюжний National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • О. В. Калюжний National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • В. В. Піманов National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • Є. А. Носар National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.59.77108

Keywords:

The analysis of combined extrude of blank made of steel 20 is carried out by the finite element method

Abstract

The analysis of combined extrude of blank made of steel 20 is carried out by the finite element method. Influence of die’s geometry on power modes of deformation and stress distribution on operating tool is defined. Tool geometry, mode of deformation and metal hardening after deformation are determined. According to calculation the stamp for process realization is designed.

Author Biographies

В. Л. Калюжний, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

д-р техн.наук, проф.

О. В. Калюжний, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук, ст. викл.

В. В. Піманов, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

асп.

Є. А. Носар, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

студ.

Downloads

Published

2016-09-07

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.