МЕТОДИ АВТОМАТИЗОВАНОГО ФОРМУВАННЯ МАТЕМАТИЧНИХ МОДЕЛЕЙ СКЛАДАЛЬНИХ ВИРОБІВ

Authors

  • В. Н. Кореньков National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine
  • А. А. Субін National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2010.59.78714

Keywords:

The software for computer-aided input of initial data as well as for the processing the geometric information directly from the product’s 3D model is described

Abstract

This paper presents the analysis of required initial data for computer-aided modules, which realize the analysis of an assembly. The software for computer-aided input of initial data as well as for the processing the geometric information directly from the product’s 3D model is described.

Author Biographies

В. Н. Кореньков, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук

А. А. Субін, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

канд.техн.наук

Downloads

Published

2016-09-30

Issue

No. 59 (2010)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.