АНАЛІЗ ПРОЦЕСУ ХОЛОДНОГО ВИДАВЛЮВАННЯ З ДИФЕРЕНЦІЙОВАНИМ ПРОТИТИСКОМ ПОРОЖНИН ШТАМПІВ ІЗ ІНСТРУМЕНТАЛЬНИХ СТАЛЕЙ

Authors

  • В. В. Піманов National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine

DOI:

https://doi.org/10.20535/2305-9001.2011.62.70035

Keywords:

The loads of forging, the distribution of specific loads on tool, mode of deformation, resource ductility of material in the volume of workpiece after deformation and finite dimensions of forged cavity were determined

Abstract

The mathematical modeling of cold forging of die cavity made of steel P6M5 in conditions of differentiated back pressure was carried out by finite element method. The loads of forging, the distribution of specific loads on tool, mode of deformation, resource ductility of material in the volume of workpiece after deformation and finite dimensions of forged cavity were determined. The experiment of the forging of cavity was carried out.

Author Biography

В. В. Піманов, National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv

асп.

Downloads

Published

2016-05-30

Issue

No. 62 (2011)

Section

Original study

License

The authors reserve the right to authorship of the work and pass the journal right of first publication of this work is licensed under a Creative Commons Attribution License, which allows others to freely distribute the work published with reference to the authors of the original work and the first publication of this magazine.